Regulation (EU) 2020/740 of the European Parliament and of the Council of 25 May ... (32020R0740)
INHALT
Regulation (EU) 2020/740 of the European Parliament and of the Council of 25 May 2020 on the labelling of tyres with respect to fuel efficiency and other parameters, amending Regulation (EU) 2017/1369 and repealing Regulation (EC) No 1222/2009 (Text with EEA relevance)
- REGULATION (EU) 2020/740 OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL
- of 25 May 2020
- on the labelling of tyres with respect to fuel efficiency and other parameters, amending Regulation (EU) 2017/1369 and repealing Regulation (EC) No 1222/2009
- Article 1
- Subject matter
- Article 2
- Scope
- Article 3
- Definitions
- Article 4
- Obligations of tyre suppliers
- Article 5
- Obligations of tyre suppliers in relation to the product database
- Article 6
- Obligations of tyre distributors
- Article 7
- Obligations of vehicle suppliers and vehicle distributors
- Article 8
- Obligations of hosting service providers
- Article 9
- Testing and measurement methods
- Article 10
- Verification procedure
- Article 11
- Obligations of Member States
- Article 12
- Union market surveillance and control of products entering the Union market
- Article 13
- Delegated acts
- Article 14
- Exercise of the delegation
- Article 15
- Evaluation and report
- Article 16
- Amendment to Regulation (EU) 2017/1369
- Article 17
- Repeal of Regulation (EC) No 1222/2009
- Article 18
- Entry into force
- ANNEX I
- TESTING, GRADING AND MEASUREMENT OF TYRE PARAMETERS
- Part A: Fuel efficiency classes and rolling resistance coefficient
- Part B: Wet grip classes
- Part C: External rolling noise classes and measured value
- Part D: Snow grip
- Part E: Ice grip
- ANNEX II
- CONTENT AND FORMAT OF THE TYRE LABEL
- ANNEX III
- PRODUCT INFORMATION SHEET
- ANNEX IV
- INFORMATION PROVIDED IN TECHNICAL PROMOTIONAL MATERIAL
- ANNEX V
- LABORATORY ALIGNMENT PROCEDURE FOR THE MEASUREMENT OF ROLLING RESISTANCE
- 1. Definitions
- 2. General provisions
- 2.1. Principle
- 2.2. Tyre selection requirements
- 2.3. Measurement method
- 2.4. Data formats to be used for the computations and results
- 3. Requirements applicable to the reference laboratories and determination of the assigned values
- 4. Procedure for the alignment of a reference laboratory to the assigned values
- 5. Requirements applicable to candidate laboratories
- 6. Procedure for the alignment of a candidate laboratory
- ANNEX VI
- VERIFICATION PROCEDURE
- ANNEX VII
- INFORMATION TO BE ENTERED INTO THE PRODUCT DATABASE BY THE SUPPLIER
- ANNEX VIII
- CORRELATION TABLE
Feedback